Hi
Does anyone know the make/pattern of green/orange wire connector used on DCC Concepts Cobalt turnout motors? They are 0.1" spacing and are a fairly common standard design, but I can't identify the manufacturer. I am trying to source a make of header pin to use to provide a disconnect facility that avoids the risk of getting wires crossed accidentally when reconnecting. The critical issue is the length of male header pin so that they engage with the on-board wire terminal. DCC Concepts just refuse to recognise the requirment. Thanks. CHRIS
Turnout motors
-
- Forum Team
- Posts: 3923
- Joined: Sun Jun 29, 2008 8:02 pm
Re: Turnout motors
Chris,
Sorry, can't answer that questionbut just to let you know, if you accidentally duplicate a post you can just delete the surplus one yourself.
Regards
Sorry, can't answer that questionbut just to let you know, if you accidentally duplicate a post you can just delete the surplus one yourself.
Regards
Return to “Signals and Control Systems”
Who is online
Users browsing this forum: No registered users and 2 guests