For the first time since starting the build of the Coffeepot, I've hit a genuine, can't-see-how-this-works, problem that re-reading the instructions won't solve...
The crossheads are two very nice lost-wax brass castings. After cleaning them up, and straightening the piston rods, they are united with the connecting rods by passing a pin in the back of the crosshead through a hole in the end of the connecting rod, and then soldering a backing plate, well, on the back.
However, this is a picture showing the pin and the hole:
Crosshead 004.jpg
You will see that the hole in the connecting rod is far too small for the pin. Indeed the pin is almost as wide as the rod-end itself... By way of scale, the total length of the crosshead is 14mm, so I don't have a great deal of metal and room to play about with.
My initial thought is to grind out (as I can't get a file on it) the pin at the back of the crosshead. Then I will drill a (say) 0.4mm hole through it, and use a brass lacemaker's pin to make a new pivot point.
Before I get out the heavy engineering tackle, is there anyone here that has either:
(a) built one of these Coffeepots or a similar Neilson and got this arrangement to work as designed, or
(b) can tell me that I've missed something blindingly obvious, or
(c) can suggest an alternative solution?
This isn't a deal-breaker by any means. The parts are all still beautifully formed, and this is the first difficulty I think that I have had and it's nearly at the end of my second tiny High Level locomotive. Knowing how good Chris Gibbon's instructions are, I do still wonder if I've missed something somewhere. Anyway, as he's now a Society member, perhaps he can chip in and tell me where I've gone wrong...
Oh, and when I have it all sorted out, I've already made the clothes peg clamp to hold it all together to be soldered...
Crosshead 005.jpg
Cheers
Flymo
You do not have the required permissions to view the files attached to this post.