kelly wrote:If you find his pace a bit too fast, then you may try to slow the video down using the YouTube controls.
Kelly, Paul,
Also try using captions/subtitles. They're automatically generated but are pretty accurate.
kelly wrote:If you find his pace a bit too fast, then you may try to slow the video down using the YouTube controls.
Winander wrote:kelly wrote:If you find his pace a bit too fast, then you may try to slow the video down using the YouTube controls.
Kelly, Paul,
Also try using captions/subtitles. They're automatically generated but are pretty accurate.
Winander wrote:kelly wrote:If you find his pace a bit too fast, then you may try to slow the video down using the YouTube controls.
Kelly, Paul,
Also try using captions/subtitles. They're automatically generated but are pretty accurate.
barhamd wrote:On the 4mm front here was my attempt at a GER chimney.
J17-chimney-IMG_8550a.jpg
The chimney was printed on a Phrozen Sonic Mini 4K.
Guy Rixon wrote:Therefore it's important to tighten down the screws in stages, and on alternate sides of the frame a little like fitting a cylinder head.
Users browsing this forum: ClaudeBot and 0 guests