I've got a very old Alan Gibson LSWR G6 0-6-0T etched kit, most parts I think are present with the exception of the boiler [which I assume was a brass tube]!
But sadly I have no instructions to check against, has anyone got a set of instructions that I could have a copy of?
Thank you
Alan Gibson LSWR G6 0-6-0T instructions
-
- Posts: 56
- Joined: Sat Jul 26, 2008 1:12 pm
Re: Alan Gibson LSWR G6 0-6-0T instructions
Have you got hold of the instructions? I have a set which i could scan if not. PM me an E Mail address.
The boiler is a piece of 18mm tube.
The boiler is a piece of 18mm tube.
Andy Westcott
-
- Posts: 95
- Joined: Sun Dec 17, 2017 8:49 pm
Re: Alan Gibson LSWR G6 0-6-0T instructions
Thanks Andy
I PM'd you earlier today with my email address.
I need to see if I have any 18mm tube.
I'm really looking forward to building this kit.
Regards Roger
I PM'd you earlier today with my email address.
I need to see if I have any 18mm tube.
I'm really looking forward to building this kit.
Regards Roger
-
- Posts: 56
- Joined: Sat Jul 26, 2008 1:12 pm
Re: Alan Gibson LSWR G6 0-6-0T instructions
Hi Roger
Email sent with instructions.
I have built one a while back, used CSB springing and 108-1 high level gearbox.
It runs well on our 'Clarendon' layout and will be seen at Scaleforum on 'Richmond'
Hope your build goes well.
Email sent with instructions.
I have built one a while back, used CSB springing and 108-1 high level gearbox.
It runs well on our 'Clarendon' layout and will be seen at Scaleforum on 'Richmond'
Hope your build goes well.
Andy Westcott
-
- Posts: 95
- Joined: Sun Dec 17, 2017 8:49 pm
Re: Alan Gibson LSWR G6 0-6-0T instructions
Hi Andy
Just out of interest can you remember which High Level gear box you used? Also what motor did you manage to fit inside the boiler.
I might just go for simple compensation.
Roger
Just out of interest can you remember which High Level gear box you used? Also what motor did you manage to fit inside the boiler.
I might just go for simple compensation.
Roger
-
- Posts: 56
- Joined: Sat Jul 26, 2008 1:12 pm
Re: Alan Gibson LSWR G6 0-6-0T instructions
Roger.
Sorry i can't remember which gearbox and motor i used and i haven't got my stock to hand. Will get it back after Scaleforum.
A picture will have to do for now:-
And the complete thing:-
Sorry i can't remember which gearbox and motor i used and i haven't got my stock to hand. Will get it back after Scaleforum.
A picture will have to do for now:-
And the complete thing:-
You do not have the required permissions to view the files attached to this post.
Andy Westcott
Who is online
Users browsing this forum: ClaudeBot and 0 guests