Alan Gibson LSWR G6 0-6-0T instructions

[RAO]

I've got a very old Alan Gibson LSWR G6 0-6-0T etched kit, most parts I think are present with the exception of the boiler [which I assume was a brass tube]!

But sadly I have no instructions to check against, has anyone got a set of instructions that I could have a copy of?

Thank you

[Weskie]

Have you got hold of the instructions? I have a set which i could scan if not. PM me an E Mail address.
The boiler is a piece of 18mm tube.

[RAO]

Thanks Andy

I PM'd you earlier today with my email address.

I need to see if I have any 18mm tube.

I'm really looking forward to building this kit.

Regards Roger

[Weskie]

Hi Roger

Email sent with instructions.
I have built one a while back, used CSB springing and 108-1 high level gearbox.
It runs well on our 'Clarendon' layout and will be seen at Scaleforum on 'Richmond'
Hope your build goes well.

[RAO]

Hi Andy

Just out of interest can you remember which High Level gear box you used? Also what motor did you manage to fit inside the boiler.

I might just go for simple compensation.

Roger

[Weskie]

Roger.

Sorry i can't remember which gearbox and motor i used and i haven't got my stock to hand. Will get it back after Scaleforum.
A picture will have to do for now:-

IMG_3410.JPG

And the complete thing:-

IMG_3411.JPG