billbedford wrote:Maybe, but I've heard stories about baseboards being mishandled (i.e. dropped) when being taken to shows and all the solder joints on rivet and ply track breaking.....
Since all the world pulled you to pieces Bill, I will come to your support! This "story" is true - I know the layout, and the Men who were there on the day.
This was in the very early days of P4, the rivets were Studiolith tinned steel. Investigation showed that the failure was not due to the soldering but was the tinning breaking away from the steel. However, the board was not dropped - it is my understanding that a sleeve was involved.
I would not hold your breath for any apologies from the vituperative assailants though if I were you Bill...
I had lots of these rivets fail in the early days (usually the ones to which the "wiring connector strip" or "Turnout bonding strip" were soldered. So the first evidence of disaster was when everything went dead. Hence as soon as functional plastic chairs came available, I threw the rivets in a drawer. They are still there if any one wants to buy them...
It was only a decade or two later that I learned that better rivets were now available...
Maybe nostalgia is not what it once was... But then I never had any issue with K&L chairs - still have a bag or two of them and they are all fine.