Laser Cut Point Sleepering
-
- Posts: 539
- Joined: Tue Aug 13, 2013 2:49 pm
Laser Cut Point Sleepering
I have a double slip to construct for my new layout and was considering purchasing one of the laser cut 'templates' to hopefully make life a little easier. However, I either can't remember who makes them or can't find them when searching. Are they still available and, if so, from whom?
-
- Posts: 654
- Joined: Mon Jan 11, 2010 8:06 pm
Re: Laser Cut Point Sleepering
C&L now do their own, there's one here, or the original Timbertracks are, AFAIK, still available, website here. HTH!
edited to substitute a double slip link for a single one!
edited to substitute a double slip link for a single one!
David L-T
-
- Posts: 539
- Joined: Tue Aug 13, 2013 2:49 pm
Re: Laser Cut Point Sleepering
Thanks for that - and sorry about the delay in replying. I couldn't find the C&L one on their website and I need a 1:6 angle, their's is 1:8. I'll try Timber Tracks, they have the correct angle - and it's less expensive!
Return to “Track and Turnouts”
Who is online
Users browsing this forum: ClaudeBot and 0 guests