Page 1 of 1

Turnout motors

Posted: Thu Feb 23, 2017 3:48 pm
by chrisyates
Hi

Does anyone know the make/pattern of green/orange wire connector used on DCC Concepts Cobalt turnout motors? They are 0.1" spacing and are a fairly common standard design, but I can't identify the manufacturer. I am trying to source a make of header pin to use to provide a disconnect facility that avoids the risk of getting wires crossed accidentally when reconnecting. The critical issue is the length of male header pin so that they engage with the on-board wire terminal. DCC Concepts just refuse to recognise the requirment. Thanks. CHRIS

Re: Turnout motors

Posted: Thu Feb 23, 2017 7:16 pm
by grovenor-2685
Chris,
Sorry, can't answer that questionbut just to let you know, if you accidentally duplicate a post you can just delete the surplus one yourself.
Regards