Turnout motors

Discussions of the prototypes and how to model them. Show us how you do it.
chrisyates
Posts: 11
Joined: Fri Sep 19, 2008 6:33 pm

Turnout motors

Postby chrisyates » Thu Feb 23, 2017 3:48 pm

Hi

Does anyone know the make/pattern of green/orange wire connector used on DCC Concepts Cobalt turnout motors? They are 0.1" spacing and are a fairly common standard design, but I can't identify the manufacturer. I am trying to source a make of header pin to use to provide a disconnect facility that avoids the risk of getting wires crossed accidentally when reconnecting. The critical issue is the length of male header pin so that they engage with the on-board wire terminal. DCC Concepts just refuse to recognise the requirment. Thanks. CHRIS

User avatar
grovenor-2685
Posts: 3060
Joined: Sun Jun 29, 2008 8:02 pm

Re: Turnout motors

Postby grovenor-2685 » Thu Feb 23, 2017 7:16 pm

Chris,
Sorry, can't answer that questionbut just to let you know, if you accidentally duplicate a post you can just delete the surplus one yourself.
Regards


Return to “Signals and Control Systems”

Who is online

Users browsing this forum: No registered users and 2 guests