Hello all,
After wiring up my layout ( a passing loop with attached siding ) I am getting a short detected by my NCE power cab and backed up my the multimeter, this short only happens when the tortoises are set in on direction.
Can anyone help?
Thanks
Sam
PS its 2 out of the three tortoises i have, haven't tested the third.
tortoise problem
-
- Posts: 135
- Joined: Wed Aug 06, 2008 7:32 am
Re: tortoise problem
I guess you're using the tortoises to switch the crossing polarity so check the connections there first. If I remember rightly, the connections aren't in a particularly logical order so it's easy to get wrong.
Re: tortoise problem
Simon, Just checked and i think you have the answer, obviously misread the instruction!!
Thanks
Sam
Thanks
Sam
Return to “Signals and Control Systems”
Who is online
Users browsing this forum: ClaudeBot and 0 guests