Flymo748 wrote:
. . . the brakeshoes are nowhere near the wheels for instance . . .
Well within your capabilities to remedy this, surely?
Flymo748 wrote:
. . . the brakeshoes are nowhere near the wheels for instance . . .
David B wrote:Flymo748 wrote:
. . . the brakeshoes are nowhere near the wheels for instance . . .
Well within your capabilities to remedy this, surely?
Ian Everett wrote: . . . . so I strengthened the inside of the bend with a thin fillet of solder. This is not mentioned in the instructions, so I am wondering if I did right?
Ian
dal-t wrote:Isn't it standard practice to solder all folded joints? I'm sure I was told that when I first started building etched kits, but I so many years later (a) I haven't a clue where the instruction came from, and/or (b) maybe modern theory says otherwise?
Flymo748 wrote:Paul Townsend wrote:Flymo748 wrote: b****y Jidenco etched kit
Flymo
As ye sow so shall you reap
billbedford wrote:The BB GWR w-irons were intended for four and six wheeled coaches.
I've attached a few photos showing which sequence I proceed in.
grovenor-2685 wrote:I've attached a few photos showing which sequence I proceed in.
The sequence does not look right to me, maybe starting from the bottom?
Unfortunately all the files have the same name so I can't sort them out for you.
Regards
Users browsing this forum: ClaudeBot and 3 guests