Hi Mark.
I noticed that you'v produced a very nice chassis/bogie etch for the GNR/ECJS twelve wheelers. Are you planing to make these available to those who are also in need ? .
Cheers.
Alan Woodard.
Mark Tatlow GNR/ECJS twelve wheelers
-
- Posts: 899
- Joined: Tue Dec 02, 2008 11:24 pm
Re: Mark Tatlow GNR/ECJS twelve wheelers
Alan,
Yes in principal once I have debugged a few points from these.
See comment about "what you get is what you see" in the main thread though!!
Pop me a note via the "contact page" of www.highlandmiscellany.com if you wish, to register interest.
Yes in principal once I have debugged a few points from these.
See comment about "what you get is what you see" in the main thread though!!
Pop me a note via the "contact page" of www.highlandmiscellany.com if you wish, to register interest.
Mark Tatlow
Re: Mark Tatlow GNR/ECJS twelve wheelers
You might want to note that the GA of the underframe shows only two truss rods, and that the queen posts have struts running from their low end inboard to the underframe cross beams.
-
- Posts: 899
- Joined: Tue Dec 02, 2008 11:24 pm
Re: Mark Tatlow GNR/ECJS twelve wheelers
Thank you to Bill for this and also the supply of the GA for one of the similar vehicles.
A modification is on the way!!
A modification is on the way!!
Mark Tatlow
Re: Mark Tatlow GNR/ECJS twelve wheelers
Hi Mark.
The bogies look great. does Lochgrom kits sell the spring/axle box castings separate? if so do you know the part number. I had a look on there site but could only find two bogie kits.
Cheers.
Alan.
The bogies look great. does Lochgrom kits sell the spring/axle box castings separate? if so do you know the part number. I had a look on there site but could only find two bogie kits.
Cheers.
Alan.
Who is online
Users browsing this forum: ClaudeBot and 1 guest