Prompted by a conversation on the GERS email list over the last 24 hours about the need for some 4mm GER headcode discs, I've fired up my CAD package...
I've had a quick think, and a play around, and the results are attached. Knowing there are a number of GER/LNER/BR(E) <spit> modellers on here, I thought I'd share these with you as well. I've tried, particularly in the handles, to compromise between fidelity and practicality when etched to 4mm scale.
- GER discs etch.JPG (82.34 KiB) Viewed 1764 times
The scale at the top of the image is in millimetres, as a guide to size.
Comments or suggestions welcome.
A quick note of caution - I may not send these off to be etched immediately. I'm halfway through the design of a fully sprung chassis for a GER 5-plank wagon in 4mm. I'd like to get that to test-etch state before sending these off to be done at the same time.
Cheers
Flymo