* Potential * GER headcode discs

If you are making something new or have found something, announce it here.
User avatar
Paul Willis
Forum Team
Posts: 2543
Joined: Sun Jul 20, 2008 6:00 pm

* Potential * GER headcode discs

Postby Paul Willis » Tue Mar 17, 2020 10:18 pm

Evening all,

Prompted by a conversation on the GERS email list over the last 24 hours about the need for some 4mm GER headcode discs, I've fired up my CAD package...

I've had a quick think, and a play around, and the results are attached. Knowing there are a number of GER/LNER/BR(E) <spit> modellers on here, I thought I'd share these with you as well. I've tried, particularly in the handles, to compromise between fidelity and practicality when etched to 4mm scale.

GER discs etch.JPG
GER discs etch.JPG (82.34 KiB) Viewed 1765 times


The scale at the top of the image is in millimetres, as a guide to size.

Comments or suggestions welcome.

A quick note of caution - I may not send these off to be etched immediately. I'm halfway through the design of a fully sprung chassis for a GER 5-plank wagon in 4mm. I'd like to get that to test-etch state before sending these off to be done at the same time.

Cheers
Flymo
Beware of Trains - occasional modelling in progress!
www.5522models.co.uk

Return to “New Products”

Who is online

Users browsing this forum: No registered users and 4 guests