Page 1 of 1

Branchlines MB35 bogie Compensating

Posted: Thu Apr 10, 2014 3:18 pm
by BrockleyAndrew
Hello All

I have a quick question regarding this bogie. An RMWeb discussion from 2007 has Jim S-W writing that these are "easily compensated". I have just had one delivered and thought I'd ask how one does that, before I start building. I realise "easily" is a relative term!
Thanks in advance

Andrew
in Brockley

Re: Branchlines MB35 bogie Compensating

Posted: Thu Apr 10, 2014 4:51 pm
by jim s-w
Hi Andrew

It's gloriously low tech but works. (fans of proper solutions look away now)

Simply extend the bearing holes downwards at one end so that axle can rock. You only need about half a mil each side and make sure you don't file any material from the top of the hole.

HTH

Jim

Re: Branchlines MB35 bogie Compensating

Posted: Thu Apr 10, 2014 8:02 pm
by BrockleyAndrew
Hello Jim

Many thanks! That does sound simple! When you say "at one end" do you mean lowering/widening both axle holes for just one of the axles? Also on the RMweb discussion (for pulling a heavy load) you recommend a larger motor and a flywheel. I've ordered neither but am not concerned so much about pulling power, but was wondering if you feel the flywheel is essential for smooth running?

thanks again

Andrew
in Brockley

Re: Branchlines MB35 bogie Compensating

Posted: Sat Apr 12, 2014 6:16 am
by jim s-w
Hi Andrew

That's right, I don't know if the flywheel is essential or not but I was advised to go for the bigger motor by Andy Mullins.

One thing to mention is they are really noisy! Branch lines sell a synthetic grease which makes a world of difference.

Jim

Re: Branchlines MB35 bogie Compensating

Posted: Sat Apr 12, 2014 11:04 am
by BrockleyAndrew
Hello Jim

Ok - thanks for the advice. I shall get building then!

Andrew
in Brockley