Good Evening All,
Unsure where to post this, but here goes:
I recently won an auction for a new old stock Heljan Class 52 D1037 Western Empress which was wired for DCC but without a decoder.
I have several ZIMO decoders in stock so put on an 8 pin large one, motor works fine but no lights either end.
I did come with one tower detached from the cardan shaft and 2 x unattached plugs for either W or R. The towers are connected to DC and motor ticks over nicely from 1
to a realistic growl at 28 on my Lenz 100 system.
Would someone kindly tell me which plug goes where at each end of the long DCC board please?
W R DC AC
AC is left blank on either end.
Thanks in advance
2 posts • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest