Inside crank axles request.

[Horsetan]

Probably a bit of an odd request, but does anyone know where I might be able to get inside crank axles made? I would ideally like to have them for the following engines:

LNE J27
SR Q1
SECR "C".

Cranks would be at the normal 90-degrees, offside leading, with the crank throws themselves broadly matching those on the driving wheels. The axle ends themselves would be the usual 1/8" diameter.

Any pointers, leads to people who might be able to undertake such work, etc. would be much appreciated.

[Russ Elliott]

Martin Finney does DIY inside crank kits. I think they're all 12" throw.

[Horsetan]

Martin Finney does DIY inside crank kits. I think they're all 12" throw.

Thanks, Russ. Yes, I have a couple of those already. Useable on the Q1, not tried on "C" yet, but throw is definitely too big for the J27, hence this request.