I have slightly revised the 3D Peckett wheels they will now be printed in a different resin which is much crisper than standard resin and has a different cure process as it is baked in the oven at 50 degrees, also I have made the wheels a good fit into the tyre so there should be no need to loctite or glue the centres into the tyre.
I will only make these wheels to fit standard Alan Gibson 3'1" wagon wheels as these although slightly under scale have a much thinner tyre face and look much finer than using a Alan Gibson bogie wheel which looks too chunky.
For P4 the axles you will need Alan Gibson 21.9mm he does three axle lengths (you will need to shorten in EM)
Prices are £8 for 5 wheels ( as this is the number I can fit on the short side of a print bed, it does give you a spare wheel to practice on or an extra if you cock one up!) plus £1.50 P&P
please email me at email@example.com
if interested I am currently looking after my mum after a hip replacement so maybe a while till I am up to full production.