I once attended a show (Pompey Girls school?) where the late Chris Kedgley was demonstrating a technique for lining that was a very novel way of doing it. I think you applied the main expanse of carefully measured and painted 'infill' .leaving the lining colour behind. I feel guilty that I have forgotten the details, especially as that lovely man took such care in explaining it all to me.
Can anyone remember the details of the method, or perhaps has a photo of something they achieved, even better? Regards, Howard
reverse lining method
-
- Posts: 911
- Joined: Sun Mar 27, 2011 6:40 pm
Re: reverse lining method
There's a technique where one paints the highlight colour, applies a dry-print transfer as a mask, sprays the body colour, and then peels off the transfer. Apparently, it's used a lot in high-end, military modelling. Wouldn't work with transfers that have carrier film, of course. I don't know if dry-print lines are available from anywhere.
There's also the method of scraping through the body colour to expose the brass, representing gold lining. I did that on one coach; it worked moderately well but the lines were a little too fine.
There's also the method of scraping through the body colour to expose the brass, representing gold lining. I did that on one coach; it worked moderately well but the lines were a little too fine.
-
- Posts: 1953
- Joined: Mon Aug 10, 2009 7:49 pm
Re: reverse lining method
Howard,
I could not recall Chris doing this but showed your post to Steve Young, an old friend of his from the EMGS, and this was his response:
"I remember he nearly always did his lining using decal sheets. He would use a lining pen to line out the basic colour of the lining and then add any additional thinner lines. He used a rule to guide the pen. I recall him only doing the straight lines. The corners and curves he added freehand after having cut out the straight line and applying to the locos. The results were very good. I know he had tried curves but decided that it was easier to do it freehand. Not sure of the make but it wasn't made by Crafty Computer Paper as theirs is in A4 sheets. Think he used an American make."
This seems similar to Guy's comments. Hope it helps.
Philip
I could not recall Chris doing this but showed your post to Steve Young, an old friend of his from the EMGS, and this was his response:
"I remember he nearly always did his lining using decal sheets. He would use a lining pen to line out the basic colour of the lining and then add any additional thinner lines. He used a rule to guide the pen. I recall him only doing the straight lines. The corners and curves he added freehand after having cut out the straight line and applying to the locos. The results were very good. I know he had tried curves but decided that it was easier to do it freehand. Not sure of the make but it wasn't made by Crafty Computer Paper as theirs is in A4 sheets. Think he used an American make."
This seems similar to Guy's comments. Hope it helps.
Philip
-
- Posts: 296
- Joined: Tue Jul 22, 2008 1:15 am
Re: reverse lining method
Here is how the Ian Rathbone does lining - starting at 2hr20min.
https://www.youtube.com/watch?v=Ne0fBH6zNkQ
While he makes it look easy, the tips and techniques that are shared are invaluable.
https://www.youtube.com/watch?v=Ne0fBH6zNkQ
While he makes it look easy, the tips and techniques that are shared are invaluable.
Cheers,
Mark.
"In the end, when all is said and done, more will have been said than done..."
Mark.
"In the end, when all is said and done, more will have been said than done..."
Return to “Painting and Weathering”
Who is online
Users browsing this forum: ClaudeBot and 0 guests