Search found 4 matches

by Major Clanger
Thu Aug 15, 2019 9:56 am
Forum: Product Information
Topic: Wizard Models
Replies: 60
Views: 6667

Re: Wizard Models

Two issues here: Overseas P&P - this is all explained under the Delivery Charges section of the T&C page on the website. Because of the way the site and my card agent work, I can't see any other way of doing it at present. Weight could be introduced as a variable, but not all the products ha...
by Major Clanger
Tue Aug 05, 2008 7:11 pm
Forum: Other Workshop Practice
Topic: Soldering tiny components
Replies: 8
Views: 5938

Re: Soldering tiny components

Holding tiny assemblies for soldering can be a bit of a problem. "Millboard matting" and "Soldering Honeycomb" have been suggested as good surfaces to solder on. See "Where to Get" 2006. (See the resources section of the web site if you missed this.) Soldering honeycom...
by Major Clanger
Sun Jul 27, 2008 10:25 pm
Forum: Railway Buildings
Topic: Midland Railway coal drops
Replies: 5
Views: 5705

Re: Midland Railway coal drops

Hi Alan There were quite a few in the London area: Camley Street by St Pancras had lots of course, but there were other depots around the place such as Walworth Road, just down from the Elephant & Castle on the LCDR line. This latter was featured in one of the magazines not so very long ago...b...
by Major Clanger
Sun Jul 27, 2008 10:21 pm
Forum: Track and Turnouts
Topic: Turnout wiring / soldering
Replies: 10
Views: 5027

Re: Turnout wiring / soldering

I can see a need to revise that Digest! Anyone using C&L parts like to contribute alternative methods? Hope this helps a bit. If building on the bench, rather than in situ, when the turnout is finished, turn it upside down and solder the feeds/bonds directly to the underside of the rails, cutti...

Go to advanced search